1 Topic by jatracy

  • jatracy
  • Member
  • Offline

When I try to launch Kinovea with a dual capture default workspace on my AMD Ryzen 9 6900HS based laptop, it takes over 30 seconds to start the cameras. I can get the cameras to start quicker (up to as fast as I humanly can) by toggling the capture off, then back on.

The cameras start almost instantaneously on the Intel i9 based laptop.

2 Reply by joan

  • joan
  • joan
  • Admin
  • Offline

Is it an IDS camera? I remember there was a similar slow down with these cameras.
Could you show the beginning of the log when this slowdown happens?

3 Reply by jatracy (edited by jatracy 2022-12-09 20:38:09)

  • jatracy
  • Member
  • Offline

I have sent several log files to your email.

Edited to answer the question about cameras.
Edited the second time to describe that the issue does not appear on my Intel i9 based laptop.

I have 4 cameras total. 3 Basler and 1 Daheng. The tests were run with 1 Basler and 1 Daheng. I can replicate the issue with 2 Basler cameras. Performing the same test with my Intel i9 and 1 Basler and 1 Daheng cameras results in no perceptible delay in loading the cameras.