1 Topic by Jeff

  • Jeff
  • -
  • Offline

Trying to use a manual connection IP camera but Kinovea constantly fails.  The IP address, subnet, and port are all correct and several other monitoring software connect fine.  Even the browser connects to the camera.  Using Win 11 pro with 2 HikVision cameras connected to a POE switch, connected to the LAN via a router.  All cable connections, no wifi.  Any ideass?
Thanks

2 Reply by zhaojia511

  • zhaojia511
  • Member
  • Offline

I successfully setup daheng GigE cameras，directly connect the RJ45 cable with a desktop`s port, tried several ip address configuration, you can give your detailed ip setup to see where is the problem.

3 Reply by joan

  • joan
  • joan
  • Admin
  • Offline

The browser might support more protocols than Kinovea, make sure to configure the camera so it produces an MJPEG stream. If that's already the case and the browser can access the stream while Kinovea can't, it could be a firewall block.